How to install china diamond saw blade for concrete on sales? The correct installation method of china diamond saw blade for concrete on sales is given. The operation seems simple, but it needs to be handled carefully. The operator is often injured due to incorrect installation.

Installation step 1: understand the basic knowledge of china diamond saw blade for concrete on sales

Familiar with the operation knowledge of china diamond saw blade for concrete on sales and scene application. Classification of china diamond saw blade for concrete on sales and maximum cutting power. Pay attention to the cutting speed and service time during use, and conduct regular maintenance and repair. The price of cutting machine in the market is transparent, from high to low, and the suitable china diamond saw blade for concrete on sales should be selected according to the enterprise's own situation.

Installation step 2: check the diamond saw blade for concrete on sales

Carefully check china diamond saw blade for concrete on sales to see if the surface is cracked or too soft. If one of these phenomena occurs, it should be replaced in time to avoid dangerous accidents during the cutting process.

Installation step 3: Align the position of china diamond saw blade for concrete on sales

Find the position of china diamond saw blade for concrete rotation shaft. The projecting part of the middle bearing box is the shaft locking device. Press the cylinder, turn the shaft with the other hand, and turn it counterclockwise. The best way is to swing the shaft left and right by hand. When the cylinder pressed at the same time meets the small hole on the shaft, the cylindrical pin enters the hole. The shaft will not turn.

Installation step 4: placing china diamond saw blade for concrete on sales

Press the cylinder, and use the other hand to loosen and remove the fastening bolts of china diamond saw blade for concrete on sales. Remove the protective disc and paper pad of the cutting sheet in order to prevent damage. Do not take out a piece of protective disc inside, put in a new one, then install the paper pad and protective disc in turn, and tighten them.

Installation step 5: Operation of china diamond saw blade for concrete on sales

At the beginning of cutting, it is not allowed to cut directly. Wait for china diamond saw blade for concrete on sales to idle for about 1-2 minutes. This is to ensure that no dangerous accidents occur during cutting.

The above is the correct installation procedure of china diamond saw blade for concrete on sales. Every step from inspection to testing needs to be taken carefully. Ensure safety during operation.