The texture of marble is hard and brittle, and ordinary tools can't cut it at all. Diamond, as a material with high hardness, is the most perfect for cutting marble, but the sharp part of diamond is wrapped with a layer of metal. Before use, scrape the metal part of this layer to expose the particles inside before normal use. Wholesale  Marble diamond saw blade in china has very high strength, which is closely related to its manufacturing process. After the continuous improvement of Wholesale diamond tool cutting technology in China, not only the quality of diamond tool cutting products has been greatly improved, but also the production of auxiliary machinery has been developed to a certain extent.Wholesale diamond cutting blade in china is used to cut various materials, so it is very important to ensure its hardness in the process of manufacturing it. However, there are basically two process methods for Wholesale diamond tool cutting products seen in the market.

During the production of Wholesale diamond tool cutting products, there are generally two methods: cold pressing and hot pressing, and the product results obtained under these two methods will be different to a certain extent. The diamond saw blade in china produced by cold pressing can relatively reduce a lot of consumption in the production cost. The relative cost of hot pressing is higher because there should be enough heat source in the production process. In terms of the final product quality, the product produced by hot pressing is obviously better. In the process of purchase, users should try their best to purchase diamond cutting pieces made by hot pressing, so as to ensure the safety and performance in future use.
When cutting with Wholesale marble diamond saw blade in china, the main points are as follows: first, check whether all accessories are complete before cutting, drop lubricating oil on the machine, and require the operator to wear protective sleeve and not to operate directly. In this way, the risk factor is too high to try easily; Second, the cut marble should be placed flat, preferably parallel to the ground, so as to avoid cutting skew, which wastes marble. The horizontal line should also be drawn at the cutting position to reduce the error; Third, if there is abnormal noise and jitter during cutting, it is necessary to stop operating the machine immediately and repair it after power failure to see what the problem is; Fourth, the cutting speed should be slow. Too fast cutting speed is easy to damage the marble, which will also cause the friction and heat generation of the cutting blade to spark and wear the cutting piece. Once the cutting piece is deformed, it can no longer be used, and a new cutting piece needs to be replaced for cutting; Third, after cutting, stack the parts in order, clean up the debris and apply protective oil to protect the machine.
There will be deviations in the production process of diamond segment for saw blade among each manufacturer, so the cost will be different, so the corresponding price of diamond segment for saw blade will also be different. If you have this demand, you can contact us.