The frame saw is more suitable for cutting large quantities of granite thin plates, while the diamond rope saw is more suitable for sawing plates with multiple specifications and different thicknesses, and is also suitable for processing more valuable granite. The diamond rope saw is effectively changing the traditional reciprocating frame saw. The diamond rope saw has many advantages in stone cutting: compared with the traditional frame saw, The power consumption of sawing stone per square meter is reduced by 30%; There is no need to apply other abrasive particles to cut granite, and the water treatment system is simple; It can quickly heal and cut plates in yellow, and its single rope cutting speed can reach 2 ~ 2.5o/h.Customized Diamond wire rope saw for stone cutting in china with better quality, higher flatness, and flatness tolerance can be controlled within 0.5mm; Easy to operate, very flexible in quickly changing the thickness of sawing plate; The installation covers a small area and saves land cost.

When using customized diamond wire rope saw for stone cutting in china, attention should be paid to: before cutting, the waste material should be shaped at the top and bottom; The waste material shall be placed on two supports and fixed with cement; A saw rope usually does not require a cutting edge. During sawing, it is necessary to determine the reasonable feed speed, which is determined by the suitable curvature of the steel wire rope in the cutting process. Usually, it is controlled and adjusted by the control cabinet according to the feedback signal.
Customized Diamond wire rope saw for stone cutting in china also has some unsatisfactory places. Although the problem is not big, it also needs to be further improved. For example, when sawing stone blocks with unstable internal hardness, there is a risk of sawing deviation. For the same block, there may be hardness changes inside the material, some parts are very hard and some parts are very soft. Because the diamond wire rope saw for stone cutting has a flexible side, when sawing this kind of waste material, it is easier to deviate than the traditional frame sand saw, resulting in uneven plate thickness. Quality problems of unqualified accuracy. In addition, for the same reason, when diamond rope saw is used for stone cutting, there is a risk of sawing out grooves, which will not happen when traditional frame sand saw is used for cutting.
In addition, the gear train, feed mechanism, hydraulic system and control system of customized diamond wire rope saw for stone cutting in china require high accuracy. If the accuracy is not enough, the constant tension of each rope cannot be realized in the cutting process. It is easy to cause poor surface quality of the plate due to the shaking of the assembly rope and the collision and interference between adjacent rope saws, which will seriously cause rope breakage, This will result in the scrapping of the whole set of ropes.