As we all know, in many occasions, 350mm diamond saw blade is often used, and its function is very important. However, there are many precautions for 350mm diamond saw blade in use. Today, the manufacturer of 350mm diamond saw blade will share the use of 350mm diamond. Matters needing attention when saw blade.

1. Please hang the 350mm diamond saw blade vertically on a dry shelf. Be sure to avoid wet places. Do not place the 350mm diamond saw blade flat on the ground or on a shelf. It will cause deformation of the 350mm diamond saw blade. .
2. When using, do not exceed the specified speed. The speed calculation method is attached for reference.
3. When using, you must wear protective covers, gloves, safety helmets, protective shoes, and protective glasses.
4. When installing the 350mm diamond saw blade, you must first confirm the performance and purpose of the saw table, and read the saw table's manual first. In order to avoid incorrect installation and cause accidents.
5. When installing the 350mm diamond saw blade, you must first check whether the 350mm diamond saw blade is cracked, distorted, flattened, or tooth-dropped, etc., before installing it.
The teeth of the 6.350mm diamond saw blade are super hard and sharp. It is forbidden to collide or fall on the ground. It must be handled with care.
7. After installing the 350mm diamond saw blade, you must confirm whether the center hole of the saw blade is firmly fixed on the flange of the saw table. If there is a gasket, the gasket must be covered; then, gently push the saw blade by hand to confirm Whether the saw blade rotates eccentrically and shakes.
8. The cutting direction indicated by the 350mm diamond saw blade arrow must be aligned with the rotation direction of the saw table. It is strictly forbidden to install it in the opposite direction, the wrong direction will cause the gear to fall.
I hope everyone can pay attention to the above eight points when using the 350mm diamond saw blade, so as to ensure the use effect.