The manufacturer of 350mm diamond saw blade tells you that the most important part of the diamond tool is diamond. This is because the diamond is mainly in contact with the object for cutting or grinding when the tool is working. Therefore, for the purchase of diamond tools, that is, the selection of diamonds, the following 350mm diamond saw blade manufacturers will introduce you to the points that should be paid attention to when purchasing diamond tools:

Selection of particle size: 350mm diamond saw blade manufacturer tells you that when the diamond particles are very coarse and there is only a single particle, the saw blade bit is very sharp and the cutting efficiency is high, but the resistance to bending strength of diamond agglomeration will be reduced; The 350mm diamond saw blade manufacturer tells you that when the diamond particles are fine or thick and fine, the saw blade can be used for a long time, but the relative efficiency is low. When selecting, the number of diamond particles is between 50 and 60.
Selection of distribution density: 350mm diamond saw blade manufacturer tells you that if the diamond distribution density changes from small to large, the sharpness and cutting efficiency of the saw blade will gradually decrease, which will cause the service life to slowly become longer; but the density If it is too large, the saw blade will become unsharp. The manufacturer of 350mm diamond saw blade tells you that if the distribution density is lower and the particle size is coarser, the efficiency will be improved. Each part of the cutter head has a different effect when sawing and cutting. When using different concentrations, the cutter head will appear in the middle of the sawing process when the cutter head is running, which is very good for avoiding the saw blade deflection.
Strength selection: The 350mm diamond saw blade manufacturer tells you that the diamond with too high strength will make the crystal difficult to be cut. The abrasive grains are polished during use, and the sharpness is reduced, which causes the performance of the tool to deteriorate; the diamond with lower strength At times, the crystal is easily broken after being impacted, and it is difficult to shoulder the responsibility of the cutting amount. Therefore, it is best to choose diamond strength between 13 and 140N.
The 350mm diamond saw blade manufacturer tells you that you need to pay attention to the selection of the binder phase and the selection of the diamond sintering process when choosing a diamond tool. There are points to be paid attention to in each aspect, and you must pay attention when selecting it.