The manufacturer of Diamond Wire Saw for Marble Quarrying tells you that among all the material categories, natural single crystal diamond is the hardest substance in the world, so its performance as an abrasive and cutting tool is unparalleled. The manufacturer of Diamond Wire Saw for Marble Quarrying tells you Take a diamond turning tool as an example. The arc radius of the cutting edge can be sharpened to the point that even scanning electron microscopes and SEMs cannot be detected. Until now, there has not been a material that can replace it. It is often used for cutting, and the mirror surface can often be obtained directly. The manufacturer of Diamond Wire Saw for Marble Quarrying tells you that it is currently widely used in instrumentation, electronics, optics and other fields, and has become an indispensable material for cutting tools. However, due to the high cost and the need for superb skills in sharpening, it has been hindering its wide range of application.

The manufacturer of Diamond Wire Saw for Marble Quarrying tells you that due to its superior performance, the application of superhard materials is constantly expanding. It has developed from metal processing to optical glass processing, stone processing, ceramic processing, hard and brittle material processing and other traditional processing fields that are difficult to carry out.
The manufacturer of Diamond Wire Saw for Marble Quarrying tells you that natural single crystal diamond is anisotropic, so the hardness of each crystal face is very different. When the tool is sharpened, the soft side is selected as the grinding surface, and the hard side is selected. As a rake face or flank face, this brings favorable conditions for grinding. Because of its anisotropy, in use, a reasonable choice of crystal face must be considered. For example, the indenter of a hardness tester uses indentation or bounce to measure the hardness of the material to be tested. However, due to the different hardness of the working surface, the results are also different. Of course, the use of a hard surface is conducive to prolonging the life. The manufacturer of Wire Saw for Marble Quarrying tells you that the wire drawing dies made of natural diamond are different from each other because the working surface of the hole is composed of crystal faces, so the hardness is inconsistent, and the wear is uneven. Because of the isotropy, the use of diamond sintered bodies and thick film diamonds becomes very advantageous in this kind of products.