language
中国
韩国
韩国
韩国
韩国
韩国
banner

What is the situation where the 350mm diamond saw blade product cannot be used

  • Categories:Industry news
  • Author:
  • Origin:
  • Time of issue:2021-08-10 10:53
  • Views:

(Summary description)When cutting 350mm diamond saw blade products, some customers sometimes find that the 350mm diamond saw blade just installed cannot be used. In other words, the cutting surface is not very good, or the burrs are too large.

What is the situation where the 350mm diamond saw blade product cannot be used

(Summary description)When cutting 350mm diamond saw blade products, some customers sometimes find that the 350mm diamond saw blade just installed cannot be used. In other words, the cutting surface is not very good, or the burrs are too large.

  • Categories:Industry news
  • Author:
  • Origin:
  • Time of issue:2021-08-10 10:53
  • Views:
Information

When cutting 350mm diamond saw blade products, some customers sometimes find that the 350mm diamond saw blade just installed cannot be used. In other words, the cutting surface is not very good, or the burrs are too large. The new 350mm diamond The saw blade or the sharpened saw blade is the same. What is the situation?

customized 350mm diamond saw blade manufacturers
The first reaction of many customers is that the 350mm diamond saw blade product is not working. They should contact the supplier of 350mm diamond saw blade immediately, and then wait for the supplier’s processing result. There is nothing wrong with doing this, but there will be a process in this process. It will be a waste of time and will affect your production. First of all, we must know how to self-check. When cutting with a 350mm diamond saw blade, a dial indicator should be prepared. The first step is to check the pressure plate and surface of the spindle. Is there an aluminum chip stuck in it, because this situation often occurs. I suddenly found that there are a lot of aluminum chips inside. Although the aluminum chip seems insignificant, it will cause the saw blade to cut during the process of pressing the saw blade. When it comes out, there will be a lot of burrs and uneven cut surface.
The second is to check whether the lubrication nozzle is aligned with the 350mm diamond saw blade product. If the lubrication is not in place, it will also produce burrs. The third is to check the radial runout of the spindle. At this time, the dial indicator can be used. , Normally, it is possible to detect that the radial runout of the main shaft is about two wires, and it is best not to exceed three wires.
 This is usually the case when the 350mm diamond saw blade product has burrs. Therefore, if you can solve some problems by self-inspection, it will not easily harm your production volume and improve your usual maintenance. Maintenance work experience.

Keyword:

Scan the QR code to read on your phone

Xinguang Diamond

WeChat official account

Xinguang Diamond

Mobile phone QR code

Tel: 86 15179308190
Fax: 86 0793-5226507
Email: andy@chinaxinguang.com
Address: Industrial Park, tianfanjie Town, Poyang County, Jiangxi Province

Copyright: Jiangxi Xinguang Diamond Tools Co., Ltd
Gan ICP Bei no.12002000

This website supports IPv4 / IPv6 accessebsite construction: 300.cn-Nanchang